For the House and Cottages

Incredibly comfortable chair-cushion: easy to sew - pleasant to rest

Pin
Send
Share
Send
Send


This wonderful chair will become not only your favorite resting place with a book or laptop, but also a great entertainment for your children, because on such a super-pillow you can lie, sit and even ride. Thanks to the plastic construction, it will adapt to all the curves of your body, and you will simply drown in its softness!

Materials and tools:

  • furniture fabric: 5 m;
  • cotton or linen: 5 m;
  • Lightning: 200-240 cm long (or two shorter),
  • filler: batting, sintepon, foam rubber or similar material;
  • as well as scissors, pins, tailor’s chalk and ruler.

1. Cut out two circles with a diameter of 140 cm from furniture fabric. If there are no special tools at hand, you can proceed as follows: cut two squares with a side of 140 cm, fold each 4 times and draw a circle line. Next, fasten all 4 layers of fabric with pins and cut a circle.

2. Cut out 2 rectangles of 230 * 25 cm (a wider strip was measured in the video lesson, but in the end it was necessary to narrow it down, because the pillow turned out to be too big; we recommend measuring 25 cm at once). We fold them face up to each other and sew along the short edge.

Fold the resulting long rectangle with one of the circles facing towards each other. From the seamy side we pin with pins and sew. The end sides of the rectangle also sew.

4. Now we join the obtained part with the second circle (all the parts are still folded with the front sides). First, fasten with pins the zipper and the long side of the rectangle sewn to the first circle. If you use two zippers, position them with sliders to each other, and then cut off the "tails" from the side of the sliders.

We slightly open the zipper and fasten with pins the second circle (again with the front sides to each other). As soon as the lightning ends, fasten the long side of the rectangle immediately to the second circle. Stitch and turn out the finished cover on the front side.

We recommend at this stage to check how the zipper works.

5. Now we sew a similar construction from the second cut of the fabric, but we do not sew the zipper, but leave a small hole: 40-60 cm. We turn it on the front side and fill it with a filler. If the filler is not enough, add polystyrene beads.

6. Sew a hole and put on a pillow cover made of furniture fabric.

And now is the time to relax on the new comfortable bag chair!

Pin
Send
Share
Send
Send